Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Alignment needed after control arm replacement? 200 1989

posted by  lrisius on  Tue Dec 22 11:31 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 17 05:59 CST 2014
[RELATED]

Thanks! Those sound like some good suggestions to test it. I'll check the upper strut mount for sure. I don't think she actually went over the curb, just kind of skidded into it obliquely. Slight damage to the rim. A small gouge in the tire. Wheel pushed back till it was rubbing slightly. Control arm crumpled but was 20 years old with some rust. Sway bar link had a slight bend in the long part, maybe 5-10 degrees?
Thanks again!
Lyle






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Alignment needed after control arm replacement? [200][1989]
posted by  lrisius  on Tue Dec 22 10:44 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.