Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't clear 2-2-4 code for Coolant Temp Sensor 200 1989

posted by  CineMan on  Tue May 19 11:19 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 15:21 CST 2014
[RELATED]

I recently swapped out the coolant temp sensor on my 1989 244 with a new Bosch OEM replacement. It didn't have an error code at the time, but I had the intake manifold off so I replaced both temp sensors, heater hoses etc... When I put her back together I got a 2-2-4 error code for a faulty coolant temp sensor.

I'd really like to clear the code and see if it sets again, but I can't get rid of it. I left the battery disconnected overnight and it is still there. I have tried clearing the codes at the diagnostic unit by holding down the button twice for five seconds. I removed fuse 4 (not sure that is the right one), no matter what I do, I still have a 2-2-4 error code on socket 6.

Any ideas?

Ryan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can't clear 2-2-4 code for Coolant Temp Sensor [200][1989]
posted by  CineMan  on Tue May 19 11:19 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.