Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re-Ring Question 444-544

posted by  agent_strangelove on  Thu Dec 4 09:36 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 5 06:07 CST 2014
[RELATED]

If you have got calipers, measure the pistons. I'm pretty sure you will find they are .02" over as well. Physically, I bet you could have standard sized pistons in there but I bet that would make a LOT of noise as the rattled around in the engine and wouldn't be correct. If the pistons look to be in good shape, you might be able to reuse them.

But my feelings are that if I am going to put the time and effort into rebuilding an engine, I want new stuff in there (i.e. pistons) but then again the last couple of engines I have rebuilt, have needed a rebore as they were very worn or had eatten valves...

Good luck...

Chris






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Re-Ring Question [444-544]
posted by  volvo65  on Thu Dec 4 08:59 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.