Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2017 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Removing Intake Manifold to access Crankcase Ventillation box 700 1991

uid 34776's pic
posted by  Ryan_R on  Mon Aug 18 03:17 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 24 13:46 CST 2013
[RELATED]

You don't have to totally remove the manifold. You just need to move it about six inches away from the cylinder head. Just remove and loosen the obvious stuff... if something's holding the manifold back, figure out what it is instead of forcing it.

Supposedly you can do this without removing the manifold... I just couldn't figure out a way to wiggle it free.

On reassembly, just be sure not to over tighten stuff, especially the nuts holding the manifold on the studs.

Don't forget to have a new manifold gasket.

Good luck!

-Ryan
--

Athens, Ohio
1987 245 DL 314k, Dog-mobile
1990 245 DL 134k M47, E-codes, GT Sway Bars
1991 745 GL 300k, Regina, 23/21mm Turbo Sway Bars





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing Intake Manifold to access Crankcase Ventillation box [700][1991]
posted by  Indiana Brick  on Sun Aug 17 13:53 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.