Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2017 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A few Questions about putting P1800 bits in my P220 Amazon 120-130 1967

uid 4846's pic
posted by  JohnMc on  Mon Apr 10 04:26 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 07:42 CST 2014
[RELATED]

"I think the bellhousing and clutch release bearing arm are different too."

Definately, but he has both. The complete hydraulic setup from the original 122 wagon parts, and the complete cable setup from the 1800E. Either bellhousing will set comfortable between the B20E and the M41. Although the later model cable bellhousing will have the proper lower bolt holes to bolt to the B20E's lower engine brace.
--
I'm JohnMc, and I approved this message.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A few Questions about putting P1800 bits in my P220 Amazon [120-130][1967]
posted by  RepairmanJackal subscriber  on Sun Apr 9 15:26 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.