Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I take them off every fall, and replace them every spring .... 200 1990

posted by  interstition on  Tue Nov 15 05:47 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 28 10:13 CST 2014
[RELATED]

Pin just inscrews all by itself. Rotor will be held solidly in place by the caliper unless you push back the brake pads.

I have found hex head bolts in the holes at the pick-n-pull. I use those when I swap to my no-hole wheels. Figure it keeps the threads protected and that if there was any attempt make the hub balance with the pin included, the bolt shoudl weigh about the same.
--
Andy in St. Paul. '89 244 153K mi, '91 745 Regina 206K, '88 244 184K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Locating pin on brake drum [200][1990]
posted by  joe pulkowski  on Mon Nov 14 13:56 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.