Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Installing Front wheel Bearing Races 200

posted by  johnny6 on  Tue Oct 26 03:19 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I'm putting new bearings in my '87 240 wagon and need some advice. (1st timer here)

In the hub where you install the races do you seat the race completely into the hub? I started to install the races and wasn't sure how deep to seat them.

There are 2 ridges and it seems like the deeper ridge is too deep. When I was putting one of the new outer races on using the old race to tap it in the new race went deeper than the first ridge almost to the deepest one. I'm just a little confused. Is there anyway to tell they are exactly evenly seated in the hub?

Any help, thank you very much.

John






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing Front wheel Bearing Races [200]
posted by  johnny6  on Tue Oct 26 03:19 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.