Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2025 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1995 Volvo 940 fuel sender and pump wiring 900

posted by  Habib on  Sun Jun 26 23:55 CST 2022
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 13 23:40 CST 2013
[RELATED]

Greeting everyone,

I have the 1995 Volvo 940 non-turbo fuel sending unit out of the tank to install a new Bosch motor. The two wiring from sending unit going down toward the pump measure 1.5mm (AWG # 14) in diameter. The wiring pigtail harness from the fuel pump measure 2.5mm in diameter (AWG #10). I need to splice the two different size wiring and I am concerned about if that is the correct way to do it. Is it safe to do this? I very much appreciate any thoughts you may have concerning this issue.
Best,
Habib.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1995 Volvo 940 fuel sender and pump wiring [900]
posted by  Habib  on Sun Jun 26 23:55 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.