Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need help and tips for reattaching Rocker Panel Moulding on 1993 Volvo 240 200 1993

posted by  rico26 on  Sat Nov 24 17:45 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 12 14:40 CST 2014
[RELATED]

Hey Volvo Sages,

Does anyone have any experience reattaching the black rocker panel moulding strip that runs from the front to the rear wheel wells? I could use some help.

I removed the moulding strips on both sides this past July in order to manage some rust on the front fender doglegs. Once the rust repair was completed I purchased 26 new moulding clips (13 per side) as the old clips broke apart during removal. The clips appear to be one-time use anyway.

The new clips pushed on easily enough and I set by gently tapping in the center pin flush with the clip. Now, I can't quite seem to get the moulding strip to grab
even one clip to get it started. There appears to be very little clearance for the moulding strip to grab on to. Any advice or tips on how to get this done would be welcome. Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need help and tips for reattaching Rocker Panel Moulding on 1993 Volvo 240 [200][1993]
posted by  rico26 subscriber  on Sat Nov 24 17:45 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.