Quantcast
RWD - Need help and tips for reattaching Rocker Panel Moulding on 1993 Volvo 240

Volvo RWD 200 Forum

INDEX FOR 12/2018(CURRENT) INDEX FOR 10/2004 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Need help and tips for reattaching Rocker Panel Moulding on 1993 Volvo 240 200 1993

Hey Volvo Sages,

Does anyone have any experience reattaching the black rocker panel moulding strip that runs from the front to the rear wheel wells? I could use some help.

I removed the moulding strips on both sides this past July in order to manage some rust on the front fender doglegs. Once the rust repair was completed I purchased 26 new moulding clips (13 per side) as the old clips broke apart during removal. The clips appear to be one-time use anyway.

The new clips pushed on easily enough and I set by gently tapping in the center pin flush with the clip. Now, I can't quite seem to get the moulding strip to grab
even one clip to get it started. There appears to be very little clearance for the moulding strip to grab on to. Any advice or tips on how to get this done would be welcome. Thanks.




 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need help and tips for reattaching Rocker Panel Moulding on 1993 Volvo 240 [200][1993]
posted by  rico26  on Sat Nov 24 17:45 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts