Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2004 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

new engine mounts and header exhaust egr valve? 1800 1972

posted by  victorsee on  Fri Aug 17 08:42 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jan 16 21:57 CST 2013
[RELATED]

Good morning all,

Getting some maintenance done on my '72 P1800 ES; and a couple of questions came up:
1. Installed new engine and transmission mounts (manual Tran); Transmission mount is fine; new engine mounts (supplied for this vehicle) raised engine a bit.. so fan hits fan shroud.. ouch.. is this common? modify the shroud?

2. Replaced exhaust system on this car, including header exhaust pipe. Seems there was a hole in old pipe for egr valve? new pipe lacks hole; again, common? cap off lead? ( I think an earlier owner swapped auto transmission with the current manual.)
Welcome any thoughts,and experience and Thank you!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New new engine mounts and header exhaust egr valve? [1800][1972]
posted by  victorsee  on Fri Aug 17 08:42 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.