Quantcast
RWD - new engine mounts and header exhaust egr valve?

Volvo RWD 1800 Forum

INDEX FOR 12/2018(CURRENT) INDEX FOR 11/2011 1800 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

new engine mounts and header exhaust egr valve? 1800 1972

Good morning all,

Getting some maintenance done on my '72 P1800 ES; and a couple of questions came up:
1. Installed new engine and transmission mounts (manual Tran); Transmission mount is fine; new engine mounts (supplied for this vehicle) raised engine a bit.. so fan hits fan shroud.. ouch.. is this common? modify the shroud?

2. Replaced exhaust system on this car, including header exhaust pipe. Seems there was a hole in old pipe for egr valve? new pipe lacks hole; again, common? cap off lead? ( I think an earlier owner swapped auto transmission with the current manual.)
Welcome any thoughts,and experience and Thank you!

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New new engine mounts and header exhaust egr valve? [1800][1972]
posted by  victorsee  on Fri Aug 17 08:42 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts