Volvo RWD S90-V90 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2023 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

what has to be done to reach the speed sensor on the differential S90-V90 1998

posted by  Don67 on  Fri Feb 5 23:32 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello,

I have been working to fix the flashing up arrow and E-W lights on my 98 S90.

I have:

1. replaced the PNP switch

2. checked the transmission speed sensor. (my ohm meter reads 567 ohms within the acceptal range of 300 to 60. I have pulled the sensor and I can not see any physical damage on the sensor.)

3. I have jacked the rear of the car up. The car is on jackstands. The rear tires are hanging about 1 inch above the floor. I can see the sensor on the differential but I do not know what has to be done to reach the sensor.

What do I need to do to be able to safely reach the sensor to test its ohm resistance and to inspect the wiring and remove and inspect the sensor?

Don67





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New what has to be done to reach the speed sensor on the differential [S90-V90][1998]
posted by  Don67  on Fri Feb 5 23:32 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.