John,

Thank you for the reply and suggestions.

I found the adhesive on the tamper-proof box to be very strong.

My ohm tester showed 1260 ohms which is way out of the acceptable range of 300 to 600 ohms.

I have been under the car looking for a way to reach the sensor and the clip on the sensor.

I am having trouble. I have a short stocky hand and can only touch the bottom edge of the sensor with the tip of my finger.

Do I need to remove any thing to make it easier to reach sensor?

I am thinking that I may need to get a very long slander pair of needle nose pliers to reach the clip and sensor.

Thanks for the earlier reply. I hope you can suggest a way to reach and replace the sensor.

Don