Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

93 240 dl- inner tie rod bellows 200

posted by  740gt on  Sat Aug 29 13:16 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 29 12:51 CST 2014
[RELATED]

I just installed one side for the inner tie rod and rubber bellow boot. When I installed, I applied grease to the inside of the joint and end of steering gear. When I put the bellow boot over the steering gear end grease got into the little hole where the small tube at the top is attached. Is it ok to leave this or take it back off and blow out the grease in the boot with air compressor?
Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 93 240 dl- inner tie rod bellows [200]
posted by  740gt  on Sat Aug 29 13:16 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.