Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2008 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Generator Pivot Bolt Tightness 444-544

posted by  jmenacker on  Sun Nov 17 09:18 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jan 21 09:31 CST 2009
[RELATED]

I just replaced the brushes in the generator on a '63 544. The charging system seems to be fine for now.

While removing the generator I found that the rear 9/16" pivot bolt was going to be extremely difficult to remove so I just took out the three 1/2" bolts holding the bracket to the engine. While out, I cleaned the exterior of the generator and took all of the bracket bolts out for a wire brushing.

The 9/16" pivot bolts seem to have a type of acorn nut on the other end. I did not tighten these nuts down too hard on reinstallation as the pivoting function would appear to be necesary to tighten the belt back up.

Now I am thinking it would be wise to ask here how tight those bolts should be torqued before seeing the generator out of my back window as I drive down the road.

Thank you for reading and thanks even more for replying,

Joe






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Generator Pivot Bolt Tightness [444-544]
posted by  jmenacker subscriber  on Sun Nov 17 09:18 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.