Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Coil Swap question 200 80

Would it matter if I used a coil from an '87 in my '80. I can see from the specs that the '87 coil has a higher output, but since the '80 is a simple electronic ignition with no computer interface....would it matter?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Re: Coil Swap question 200 80

    you should be careful as to which coil is used

    the resistence is matched to the ignition amp as well as the impulse transmitter

    failing this may put undo heat into the FINE wire windings and cause a failure (short)

    bosch coils rarely fail so check for other problems

    hope this helps

    kgb








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Re: Coil Swap question 200 80

      Thanks for your response.

      Actually there's nothing wrong with the '80. I had previous problem with my '87 and had replaced the coil in an attempt to solve that problem (it turned out not to be the coil). So now I have an extra coil - from the '87. I was reoganizing my spare parts collection and I wasn't sure if I could consider this coil a "spare" for both cars - or even if it could be used as a test coil - (if/when I had any problems in the '80 w/ ignition that I want to troubleshoot). Thus my question.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.