Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

93 240 5 speed, Can't Insert Key in Ignition 200 1993

posted by  pageda on  Sun May 19 10:50 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

Art
Yes the end would wiggle, I never tried pulling the rod out from the back but I thought about it.

Spraying and tapping the housing did finally allow me to get the key inserted and extend the rod.

I have a graphite spray that has a solvent like carrier that evaporates leaving the graphite. Do you think that's a good idea? I also have a PTFE spray that sets up like a grease, not sure grease is a good idea?

The key hung up in the tumbler and would not not go in a few times but I kept working it to the point I think whatever was in there was at least dislodged now and not causing problems.

Now I need to reassemble the mess I created and hope it doesn't happen again.

Thanks
Dan

Update
It's hit and miss as to the tumbler working so I think I need to replace or get repaired . Do you think a locksmith can do this with the lock installed?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 93 240 5 speed, Can't Insert Key in Ignition
posted by  pageda  on Sat May 18 13:58 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.