Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Any Loosely Fitting OE Volvo Rear lower Control Arm Bushings Out There? 200

I've always been a firm believer that it is foolish to use aftermarket parts - false economy.

The bushings I wrote about are original Volvo parts right from Tasca. Perhaps I should say, allegedly authentic Volvo. I hate to be so cynical, but when I read about counterfeit chemotherapy drugs and crayons laced with lead I realize that anything is possible - for a buck.

I didn't use a wrap-around to measure them, but just measuring for major and minor diameters (being stamped, they aren't exactly circular) and comparing left to right, I found the left bushings to be .009-.010 in. smaller on the OD than the right ones.

I have some new ones coming from Tasca. I have a feeling I might end up popping in right handed bushings on both sides just to get the necessary interference fit; most likely if the 3 i received are not sized correctly the other 30,000 aren't either.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Any Loosely Fitting OE Volvo Rear lower Control Arm Bushings Out There? [200]
posted by  RicoS  on Wed Nov 30 16:17 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.