Volvo RWD 444-544 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2021 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How do I go about putting my new rubber flooring over my clutch & brake pedals? 444-544

posted by  59445 on  Thu Dec 1 20:33 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 00:40 CST 2014
[RELATED]

An obvious question, I suppose.
I took the rubber off the pedals, but, of course, I will still have to make holes in my rubber flooring to accommodate the pedals. There are small hole patterns for the hi/low beam, clutch & brake pedal in the rubber flooring but, of course, the rectangular metal clutch & brake pedals are much larger than the small round holes.
My rubber flooring is new so I want to do this right.
I suspect I make some kind of slits from the clutch & brake pedal holes on down just enough to slip the rubber flooring over the pedals, right? I just don't want to create a situation where the slits I make run or get bigger in the future.
Thanks in advance for any/all help.
Photo/photos a plus. :)
Regards,
Jim






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do I go about putting my new rubber flooring over my clutch & brake pedals? [444-544]
posted by  59445  on Thu Dec 1 20:33 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.