Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2010 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Prop shaft hangar bearing questions 120-130

Barry,

I don't have a torque spec for the big nut. I guess it's just a "get it good and tight" thing.

There are two sizes of rubber support donut, and only the larger, later one has the spring. Odds are your '69 uses the same one as your '67, or that section of the tunnel would have to be different. '67 has the smaller donut with no spring.

The splines are not keyed in any way. You should be able to insert them however you need to. They can be picky to get started.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Prop shaft hangar bearing questions [120-130]
posted by  uncle_bagley subscriber  on Sat May 29 11:09 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.