Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Urethane bushings ? 200

posted by  David Samuels on  Fri Nov 27 12:32 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 12:23 CST 2014
[RELATED]

Poly SuperPro TABs from FCPG are absolutely the way to go IMHO. This is a topic that comes up regularly on the board. Lots of posts including tons of how-to info. I think the newest and best idea to come along is the hole saw to remove your old rubber bushings. Get an extra deep one, not just the garden variety from Home Depot. (holepro.com)

Use a 2" wire brush on a heavy duty drill to clean out the inside of the shell after you drill out the bushing.

DS






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Urethane bushings ? [200]
posted by  nabramson subscriber  on Thu Nov 26 15:40 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.