Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2024 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1800E problems after rebuild. 1800 1970

posted by  Phil S. on  Mon Apr 30 06:33 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

The trigger output of your breakerless conversion doesn't go directly to the coil -- it goes to the white tach wire. The other tach wire into the engine bay (I should this as being orange) hooks to the coil negative. That puts the tach in series with the coil trigger signal.

The red wires to the tach are lighting (as I'm sure you've seen), and there's a green wire to the voltage stabilizer (regulated 10V supply). I remember there being a black ground that goes between one of the two mounting clamps and the knurled knob that fastens it.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1800E problems after rebuild. [1800][1970]
posted by  MLMSYSTEMS  on Fri Apr 27 14:39 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.