Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Head gasket in Backwards???? 91 240 200

posted by  Strong-Pimp-Hand on  Sun Oct 29 14:04 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 8 12:15 CST 2009
[RELATED]

That is right.

There are two tabs sticking out. After spraying on copper sealant, I used the tabs to handle the gasket and get it over the alignment studs.

You did it right, don't fret.

Erling gaskets are a little different, but high quality.


--
Enem v15 cam, adj. cam gear, new head, trans cooler, stainless brake lines, e-fan, braces, IPD sways, 100% poly bushed, Bils, boxed front & rear arms, wagon lowering springs, FWD rims, 25/32mm adapters, powder coated stuff, zero mile-d, & more






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Head gasket in Backwards???? 91 240 [200]
posted by  DHartlein  on Sun Oct 29 11:45 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.