Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

need insight into rear caliper replacement - tool clearance 200 1988

posted by  Dave Stevens on  Thu Apr 4 16:06 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jan 1 02:36 CST 2012
[RELATED]

Try jacking the axle up a little or pull it down a bit to move the gap in the springs. Never had a problem getting at the caliper bolts with a 1/2" extension through the springs on an 18" breaker bar, 32" breaker is a breeze. Factory used loctite so first time off is the hardest.
--
Dave -still with 940's, prev 740/240/140/120 You'd think I'd have learned by now






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New need insight into rear caliper replacement - tool clearance [200][1988]
posted by  tbb2 subscriber  on Wed Apr 3 12:04 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.