Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2003 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Oil box replacement and using copper turing for venting 850 1994

posted by  dick on  Sun Apr 24 07:52 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 3 15:24 CST 2014
[RELATED]

Some time back I posted re: replacing the oil separator and substitution of metal tubing to replace the plastic stuff. I have successfully used 3/8 inch soft copper tubing (from Lowes) as a substitute. Used the rubbed 45 degree elbow from the oil box and the soft rubber insulation from the plastic tubing to cover it. The elbow is a tight fit to the copper, but works well and also used another similar elbow on the inlet to the turbo input. Used just my hands for bending with no kinks. You do have to be careful as these are gental bends.

Also tried using small brass tubing for some of the smaller plastic, but was not as successful with bending. Used vacuum hose for the curves.

Cost: less than $5.00

dick






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil box replacement and using copper turing for venting [850][1994]
posted by  dick  on Sun Apr 24 07:52 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.