Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2002 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Can't clear code 850 1993

posted by  Fxral on  Thu Mar 11 15:53 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Car goes into limp mode after15-20 minutes of driving.Flashing arrow comes on.Retrived Code 232 from A1 plug.
I have changed the speed sensor(the one located on top of tranny just aft of the trans.main wire connecter two wires to connector from sensor and pins16/17 at the connector)Also flushed and changed the fluid.
So two questions:
-Did I change the correct sensor for this fault code?
-I can't get the code to clear. When trying to clear code I have noticed that when I plug into the A1 socket the red light glows dimly even before I push button to retrieve any codes.
It does not glow (but I can get codes)when I plug into the other sockets.Could this mean anything??
I appreciate any and all help.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can't clear code [850][1993]
posted by  Fxral  on Thu Mar 11 15:53 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.