Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2015 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Upper Engine Torque Rod Bushing-Urethane 850 1994

posted by  someone claiming to be stripping90 on  Thu Nov 19 03:32 CST 2009 [RELATED]

Any body install one of these?
Upper Engine Torque Rod Bushing-Urethane ,this is a two part bushing that comes with a sleeve(I have used something similar on the rear end of a 240).I assume that I can leave the original bushing shell in the torque rod,cut and clean out all remains of old bushing,install new two part bushing and sleeve?
(1)Is there an easy way to remove old rubber w/o the use of flame?(I'm considering a utility knife followed by a rotary tool)
(2)Is the rotational position of the new bushing of any importance? (it looks pretty solid)
(3)Is there a recommended lube to aid in installation?
(4)Has anyone had bad luck with the two part bushing?
T.I.A.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Upper Engine Torque Rod Bushing-Urethane [850][1994]
posted by  someone claiming to be stripping90  on Thu Nov 19 03:32 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.