Volvo AWD S40-V40 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2019 S40-V40 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Check Engine indicator does not go off after stalled engine S40-V40 2000

posted by  KlausC on  Thu Oct 8 05:00 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

More people should have scanners, it saves a lot of headaches. Go ahead and clear the code and see if it comes back. The p0335 (Crankshaft Position Sensor A Circuit Malfunction) might have been caused by a loose wire or connection that was pulled by the engine movement when you stalled.

Check your codes again in a couple of days even if the CEL does not light up. And I suggest checking for codes every time you change the oil. There are times when codes have to be stored multiple times before a CEL is turned on. This will give you a heads up for pending problems.

Klaus
--
Proud owner of a 1967 220S. If I had more room, I would have more Volvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Check Engine indicator does not go off after stalled engine [S40-V40][2000]
posted by  malcho  on Fri Oct 2 23:35 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.