Volvo AWD S70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2001 S70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: engine stabilizer mount replacement S70 1998

posted by  someone claiming to be jlfox on  Tue Oct 30 21:43 CST 2001 [RELATED]

Did this job recently on a 95 850

Used a saber saw or a hacksaw to cut the plastic outer shell of the bushing from the inside and it slides right out. To press it in, used two pipe flanges and washers and a long bolt and nut. The flange is normally used to bolt the end of a pipe to a wall or floor and gives you clearance for the end of the bushing. Bolt must pass thru the center hole (bring the old one to the hardware), and several flat washers as reqd. It was not possible to get the new mount completely centered, but within 1/8 inch is close enough. Forget chisels and large hammers.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New engine stabilizer mount replacement [S70][1998]
posted by  someone claiming to be db  on Tue Oct 30 09:20 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.