Like earlier posts, I have a headlamp that has moisture. I will make the "quick fix" on that lamp; however, my other lamp was pounded by a rock resulting in a crack in the glass. I had all good intentions to replace it myself, but after realizing that the bottom two bolts are impossible to get to from any angle using every posisble combination of swivel, extension, low profile socket wrench and/or crescent wrench, I have concluded that, YES, part of the bumper moudling has to be removed. Is this something I should tackle? If so, are there any secrets on how to remove the moudling without damaging it or the clips that hold it in?

I have a T-6 Executive model which has the body matched moulding under the headlight like in 2002 and later models. (not the black moulding)