Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2005 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front Cam Seal - P A N I C ! - Is there some trick?? Please Help! 850

posted by  Steve@CBE on  Wed May 4 22:47 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

hi again,
i do it by wedging a small screwdriver (tap lightly with a small hammer) between the alloy housing and the seal then levering the edge of the seal out, do this on oposite sides of the seal and it should come out enough to grap it with some pliers. you may mark the alloy slightly but this is not so bad as you can put a smear of sealant around the outer edge of the rubber seal upon installation. also this way is better than marking the cam surface.

steve.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front Cam Seal - P A N I C ! - Is there some trick?? Please Help! [850]
posted by  bhs82  on Wed May 4 15:03 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.