Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

From the 700 FAQ 200 1984

posted by  Erling on  Mon May 2 05:45 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 22 00:57 CST 2013
[RELATED]

"Be sure to clean out the buckets which slip over the valve and remove all the husher pieces before reassembling and installing new hushers. Your clearance will not change, but measure if you like. You are only inserting a rubber shock absorber not modifying the cam or lifter. However, if you have new hushers installed it makes it tough to feel properly with a feeler gauge, although they will compress down after a few minutes of hot operation and the valve clearance will revert to normal. I complete the valve clearance process before I install the new hushers."

Erling.
--
My 240 Page






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New valve lash adj. with valve silencers [200][1984]
posted by  kenneth cardell  on Mon May 2 03:43 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.