Volvo RWD 900 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 8/2010 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing b6304f Head Gasket 900

posted by  Rule 308 on  Sat Apr 30 06:58 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 8 09:20 CST 2012
[RELATED]

I take the manifold off and I usually seperate it at one side or the other on the 6 short rubber hoses. When I have the head off of the car I go ahead and remove the short little manifold and replace the gasket underneath before I go back together as this gasket is known for blowing apart. No I do not use new head bolts. I leave the cam gears attached to the cam shaft so I do not have to mess around with dialing the cams back into zero when I set it up. Otherwise it is a typical white engine head gasket.

Mark






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing b6304f Head Gasket [900]
posted by  living in the past  on Sat Apr 30 05:35 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.