Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 5/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

OEM Tow Hitch - Receiver Size? 700

posted by  Kane on  Sun Apr 24 08:08 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Actually, 1-1/4" is typical to Class II, and 2" typical to Class III, even though the weight limits on a Volvo put both in Class II.

Anyways, it's just another of Volvo's proprietary things. I'd find a steel fabricating shop to cut two pieces of 1/2" steel (or 4 pieces of 1/4" steel) out of their scrap, have a hole drilled or burned in 'em, and tack-welded to the existing receiver to space it down to a 2" square. To secure your accessories, you will need a longer bar, but that's about it.

Otherwise, you'd be looking at spending $$$ at Volvo for an OEM drawbar that's very limited IMHO.

-- Kane
--

While I would never deliberately mislead anyone, take into consideration that any information and advice provided was at no cost to you.

6 Volvos in SoCal, from '64 to '94. See profile for fleet infomation.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New OEM Tow Hitch - Receiver Size? [700]
posted by  dnvolvo  on Sun Apr 24 07:52 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.