Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear trailing arm bushing - have tools, still no go

posted by  Rambutan on  Mon Apr 18 10:23 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 20 06:51 CST 2007
[RELATED]

I got the instructions e-mailed to me from IPD. The only thing I did wrong was not lubricate the tool.

I ordered another tool shaft to try again. I will also have to pound the bushing back in so the bushing tool doeesnt go inside the sleeve as it is now flared out.

I have an electric imact wrench, no air. IPD says not to use one but...I may also resort to a reciprocal saw to cut the sleve in pieces. I can pick up one of those saws for cheap, or just rent one.

Thanks again for your help.

Ram






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear trailing arm bushing - have tools, still no go
posted by  Rambutan  on Sun Apr 17 17:13 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.