Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Installing a drawtite hitch wiring system 900

posted by  RepairmanJackal on  Mon Apr 11 14:39 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 10 09:52 CST 2014
[RELATED]

It looks easy, just run a hot wire down from the battery, hook the wires up the the appropriate tail lights. Very easy. Except for one thing. The Drawtite trailer end plug goes on the outside of the car. The kockout plate that volvo put in there uses a 3/4" neoprene gasket to keep out water. The Problem? The plug IPD-supplied tow hitch wiring kit is 1 1/2" wide. I can't possibly put it through the hole. The other end of the wires goes to the regulator. The only way to install it is to cut the brand new $40.00 wiring setup and re-splice it. Any ideas?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing a drawtite hitch wiring system [900]
posted by  RepairmanJackal subscriber  on Mon Apr 11 14:39 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.