Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing control arm 200

posted by  Danny Mac on  Mon Jan 31 02:14 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Personally I would change the ball joints and outer tie rod ends now before you get the alignment. Ball joints are very easy.. four bolts to the bottom of the strut tube and out they come (on later models). Then you just place the holder in a vise & remove the ball joint nut & reassemble.

Have Fun!
Danny Mac






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing control arm [200]
posted by  morsing240  on Sun Jan 30 20:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.