Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Intake Manifold Torque Specs or Techniques?? 200

uid 27's pic
posted by  Art Benstein on  Sun Jan 2 12:28 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

I've never used a torque wrench there (I could count on one hand the places I have used torque wrenches) but I do try to tighten in stages from center outward, paying attention to which nuts seem to need more just after tightening one adjacent.

I've seen some pretty ugly intake manifold gasket failures, but so far none I've replaced, just ones that came with the cars. Am I running on good luck or are they all about to give up the ghost?




--
Art Benstein near Baltimore Crrrrazy Ray's!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake Manifold Torque Specs or Techniques?? [200]
posted by  DougC  on Sat Jan 1 13:01 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.