Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Drive Belt Install Trouble 200

posted by  Toddlie on  Wed Oct 13 01:12 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 8 06:11 CST 2014
[RELATED]

Thanks to ALL of you I was able to successfully change the front oil seals, timing belt, water pump, accessory bushings (all of them), thermostat and radiator hoses.

I was trying to install a set of Continental drive belts (I got from Groton).

I even went so far as to remove th alternator adjusting bracket. I pushed the alternator until it would go no further but the belts seemed about 4 mm short. They would not even go around the first pulley, much less to the inside. I never tried the PS or AC. I just figured they were all that difficult. I know new belts are tight and should be, but are they supposed to be that tight? I have a 1988 volvo 244.

the belts they gave me are:

V-Belt Set BEC-145-010918
PS Belt BEC-145-010850
AC Belt BEC-145-040975

If these are the correct belts, anything I can do to stretch them out a bit before trying it again? Any help would again be appreciated.

Todd :-)
--
1990 245 Wagon - 187000 miles; 1988 244 Sedan - 123000 miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Drive Belt Install Trouble [200]
posted by  Toddlie  on Wed Oct 13 01:12 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.