Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Length of steel tube for strut tower brace 200

posted by  unggthat on  Wed Oct 6 17:05 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Mar 6 10:37 CST 2014
[RELATED]

What I did was to go buy 10 feet of 3/4" electrical conduit, then measure it myself and cut. After getting the bends right(it took me a few tries), I was able to see exactly where I needed to drill the holes. Worked for me. I don't have the exact measurements though, sorry. The things are my car are strong enough that it seems like you could lift the car by them...probably couldn't, but they are stiff...and definitely thicker than the stock bars. Anyways, good luck,

Nate Gundy
--
'86 240DL sedan, 260K miles, M46, K cam, 25/23mm sways, 260 front and wagon rear springs; http://valvespringcompressor.weblogs.us/






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Length of steel tube for strut tower brace [200]
posted by  someone claiming to be Driver  on Wed Oct 6 16:29 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.