Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Idles at 2500 RPM 200 1982

posted by  ghunger on  Fri Oct 1 09:19 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

1982 242 GLT, B23E with Kjet CIS injection.
I had to replace the main wiring harness adjacent to the block. I tore off the intake manifold and also removed the air fuel unit. I separated the fuel distributor from the air fuel control unit housing in order to degrease the latter. Twenty two years of returned crankcase gases results in quite a bit of gunk.

After reaassembly the engine started, however was running noticeable higher than at Idle. Within 30 seconds the rpm went to 2500 and stayed there. Adding throtle increased rpm and when released it settled again at 2500. Idle adjustment screw on the front side of the throttle body would not reduce idle speed, even when fully closed.

I am wondering if I have messed something up in the air fuel unit. Any ideas
Thanks.
Gordon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Idles at 2500 RPM [200][1982]
posted by  ghunger  on Fri Oct 1 09:19 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.