Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Part 1: Impressions of IPD antiroll bar effects? 200

I just put Turbo bars on my 81. The front one is 23mm. The local Volvo dealer had exactly what I needed to install new Volvo front sway bar bushings.

#1273184 bushing, need two.
#1330185 clamp, need two.
#1359391 brace, need two.
#1205991 end-link bushing, need four.

Total price for the ten pieces, not including the bars, was #46.66.

These are standard genuine Volvo rubber bushings with new-style clamps. It all went together nicely. No problems so far.

The car handles great in my opinion. While I was in there, I did all the control arm bushings (The rears were shot.), Sachs Advantage struts and shocks, strut bearings which were noisy, and front brake pads which were almost gone. All in all, the improvement in handling is quite noticeable. It's not too harsh.
--
Thanks everyone for all the information and advice, Doug C. 81 242 Brick Off Blocks, stock, B21F (non-Turbo), M46; 86 244, B230, 140k , auto.
--
Thanks everyone for all the information and advice, Doug C. 81 242 Brick Off Blocks, stock, B21F (non-Turbo), M46; 86 244, B230, 140k , auto.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Part 1: Impressions of IPD antiroll bar effects? [200]
posted by  Ken C subscriber  on Sun Sep 19 10:17 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.