Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Right turn signal 200

posted by  Runinturtle2 on  Sun Aug 29 07:07 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

The wires entering the back of the turn signal housing may be corroded or failing. If you have the single square headlamp: to access, disconnect the headlamp & turn signal wiring, then pull the four nuts from inside around the back of the headlight. The headlight support comes forward and holds the turn signal assembly. Check the sharp bend where the wiring enters the back of the turn signal housing.

See this post by wxman: http://www.brickboard.com/RWD/index.htm?id=845017
--
Jim (90 244DL 170K miles) turbo sways w/poly, front struts & bushings, OD wiring






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Right turn signal [200]
posted by  someone claiming to be VolvoDriver  on Sun Aug 29 04:49 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.