Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rear Engine Seal R&R

posted by  rstarkie on  Wed May 19 02:39 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

You would be able to drive the seal out now. Just make sure you support the holder properly. A board with the correct size hole cut in it comes to mind. A hole (or radius) small enough to support the holder but big enough to not contact the old seal.

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear Engine Seal R&R
posted by  Zee subscriber  on Tue May 18 20:53 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.