Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2005

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

inner tie rod replaced, but no locking mechanism?

posted by  Five Bricks on  Mon Apr 19 04:37 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 22 15:09 CST 2007
[RELATED]

There is no formal locking mechanism in the sense of a locknut or jam nut. There should be a washer with a tab that indexes with a notch in the rack end. Make sure that you reused the old ones. If you didn't, get a new set and install them befor you drive the car. Also, when you tighten the new tie rod, use a counterhold wrench on the last tooth on the rack.

Good luck.
--
'88 240GL, '90 240DL, '91 240






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New inner tie rod replaced, but no locking mechanism?
posted by  mentalystic  on Mon Apr 19 03:59 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.