Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

speedometer cable problems 200 1981

posted by  Trev29 on  Tue May 27 01:55 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 05:56 CST 2014
[RELATED]

"I can't unscrew the cap on the cable end because it keeps spinning around so i make no progress"
Oh, okay. when you removed the bolt was there a metal plate that came off with it? Perhaps if you replaced the plate and bolt it will hold the unit from turning while you loosen the cap with vise grips.

If you have a haynes manual check page 7a-5 (also 7b-4 and 12-15). According to the book there are "machined flats on the bearing housing" which you unscrew with a wrench to access the gear. Maybe that plate hits against the machined flat and stops it from turning while you unscrew the cap? Or you can hold the housing with a wrench while you turn the cap?

I'll crawl under my car later today and see if I can make any futher suggestions later.
--
'80..245..M46...b21a..SU carb..






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New speedometer cable problems [200][1981]
posted by  Mk245GLT  on Sun May 25 03:53 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.