Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Anyone ever reset the piston in the brake junction block?

posted by  someone claiming to be 2oldvolvos on  Tue May 20 05:33 CST 2003 [RELATED]


my 89 240 dl recently gave me a brake failure warning. it seems that the warning is detected by a piston in the brake junction block.

my manual glosses over the procedure to reset the piston and so i am confused.

when i removed the switch wire from the block and unscrewed the nylon plug, all i could see is a small brass thing about the size of a broken golf tee with a spring on it. i removed those 2 pieces. under that appears to be another nylon plug with a screw driver slot in it.

not only do i not see the piston to reset but i dont have a clue what to look for.

i have a feeling it will not be easy to remove the nylon plug with the screw driver slot.

any advice?

i am about to replace my master cylinder. maybe i will get lucky and the piston will move itsself back into position when i pump the pedal but i doubt it.

please help. thank you.

2oldvolvos






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Anyone ever reset the piston in the brake junction block?
posted by  someone claiming to be 2oldvolvos  on Tue May 20 05:33 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.