Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Warped/bent caliper?- girling with abs 700

posted by  jchiodi on  Wed May 14 09:35 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Feb 25 11:26 CST 2013
[RELATED]

1990 740 with new style girling-ABS

Recently doing front brakes again, and I could not get the caliper to go over the new pads! These are the correct pads, (same parts from same place as last time-Autozone). The drivers went on okay, but the passenger side would not.

It appears that the outboard side of the caliper, opposite pistons, it getting caught on edge of pads.

The pistons are fully retracted and I can see space between them and the pad inboard. I usually would just loosen top bolt, and remove bottom bolt, and flip up the bottom, and replace pads.

It worked okay on drivers side, but even taking off caliper completely I could not get it to fit right. The caliper would fit over the pads, but not line up with the boltholes!

Could I have a bent caliper or mount, or am I getting old enough to start forgetting things I should remember?

thanks for any help
jc
--
1985 740gle na, 1990 740gle 16 valve






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Warped/bent caliper?- girling with abs [700]
posted by  jchiodi subscriber  on Wed May 14 09:35 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.