Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

how remove 2 wire oil pressure sender? 200 1986

posted by  Strackerjack on  Tue May 13 05:44 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 19:11 CST 2014
[RELATED]

I've found a gauge cluster in a yard here and can't seem to figure out how to get the oil pressure sender off the block...

It looks like between the sending unit and the block there is a bolt head which would be impossible to get from above (unless removing the oil filter would help?)

Am I correct in assuming that I must get an open end wrench on it from underneath the vehicle? Anyone know what size wrench I'll need?

tia,

jack
--
Bad Blue, '86 245, 250,000 mi., Columbus, Ohio






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New how remove 2 wire oil pressure sender? [200][1986]
posted by  Strackerjack subscriber  on Tue May 13 05:44 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.